On the plant floor, one blown bottle defect or a heating-tunnel fault is all it takes to stop the line. You need an infrared lamp that drops in and behaves exactly like the original—no retuning the heating profile, no gambling with downtime.
What actually matters under the hood
We build the EvoBLOW heater lamp as a direct-fit emitter, not a generic swap-in. The quartz tube and halogen/IR element are held to OEM dimensional tolerances and matched thermal behavior. Typical configurations run 1200W to 2400W, 230V or 460V, with R7s connectors and the right arc length so the lamp seats properly in the reflector. That’s what keeps preform heating repeatable. Emissivity and spectral output are tuned for PET stretch blow molding, so you get stable preform skin temperature and consistent biaxial stretching.
Why this matters on Sidel, Krones, SIPA, Husky, SACMI, and Nissei ASB machines
When the heater lamp matches the machine’s expected parameters—Sidel, Krones, SIPA, Husky, SACMI, Nissei ASB—the heating tunnel doesn’t need a full recalibration after replacement. That means fewer scrap bottles, fewer profile tweaks, and more uptime. Energy use stays where it should be because the output is matched to the machine’s design, and the lamp’s thermal response supports fast, stable cycling. In practice, you keep the same cycle speed and wall thickness control you were running before the failure.
The shop-floor details you can’t skip
Installation is straightforward, but treat the lamp like a precision component. Verify voltage and connector type against the machine label, and make sure the wattage rating lines up with the reflector and zone controller. **Don’t touch the quartz with bare skin.**Oil residues create hot spots and cut life short. If your line runs long hours at maximum temperature, plan replacements during scheduled maintenance windows. It’s the cleanest way to avoid unplanned stops.